Re: is Tip and Flip cab dolly available?
Quote:
Originally Posted by Jason Banks
Landarts, it looks like your plans call for .095 wall tubing which is thicker than the 14ga(.0747) that I used. I guess that works better for your 1.75 sleeve. I would be careful with the placement of your wheels. To make sure it is easy to tip. My wheels at the front are positioned behind where the cab is mounted. I was also working with mine a few times this week and you can see I actually have the parts that are designated at 57 inches long on the plans left longer(taller) and I seem to relay on that extra length when I'm flipping to keep it from slamming on the ground or wheels. So... it might be advisable to keep them longer.
|
Thanks Jason Banks I will keep that in mind. I was going to leave the ends open so if i need to extend I can just sleeve and weld or clevis pin from the side of the tilt frame. Thanks!
|