got most of the truck little bits done . today was plow lights / plow pump wiring day . used some sptt ( on/off/on ) switches to control stuff the way i like it to be . and used some relays to do the big amp work under the hood and keep the little amp work under the dash .
plow lights on 1 switch do low/off/high separate from truck lights .
clutch for plow pump on engine is 12volt/off/joystick on controlled . helps warm the fluid up on super cold days with pump going 12v feed all the time for the first few min . then i swap it to joystick control only in up/left/right mode .
still need to find final place i want extra gauges and be done .
then cut the hole in the floor for the 3 shifter levers . going to remove the carpet since its super clean and a work truck . my other 2wd build truck has a blue inside and needs a nice carpet so its time for a swap out . then maybe i might get a rubber mat kit for this one . ran the old truck 12 years just bare metal