Re: How to properly shorten a Fiberglass tool box insert
is there something special about the area where the latch and hinges are?
fiberglass is fairly easy to work with...the best option would be take a section out of the center, and join the 2 ends in the middle..but removng a section from either side of the latch will work also
you can leave a small gap between the pieces for resin to flow into , and overlap the fiber over the cuts on the outside of the box for the strength,,,then sand the inside smooth..the outside wont show as it will be under the bed
Last edited by mongocanfly; 09-27-2020 at 04:16 PM.
|