Thread
:
1973 K20 Build Thread
View Single Post
06-01-2011, 07:42 PM
#
154
TheWhiteElephant
God is good!
Join Date: Sep 2010
Location: Texas
Posts: 689
Re: 1973 K20 Build Thread
Then I sprayed the hubs with high heat Rustoleum...
I didn't want to go out and have the studs pressed into the new rotors, so after tapping them in from underneath, I finished them off like this. I used several washers so that I wouldn't have to thread the lug nut too far. I also smeared some anti-seize between the hub and rotor.
I used a rented bearing/seal installer and installed the inner bearing cup into the hub. Here are the correct part numbers for the outer bearing, inner bearing, inner bearing race/cup, and inner bearing seal from top to bottom.
__________________
Mando
"It takes a smart man to know when he's stupid." -- Barney Rubble
My build thread:
http://67-72chevytrucks.com/vboard/s...d.php?t=430367
Last edited by TheWhiteElephant; 06-04-2011 at
04:13 PM
.
TheWhiteElephant
View Public Profile
Find More Posts by TheWhiteElephant