[Clint72]

Man I'm glad I found this forum, y'all are awesome!
So I tested the wire to the sender, and I have it hooked to pin 6 now.
The second wire coming from pin 6 I can just snip and leave disconnected correct?
What about the second green wire coming from the harness?
It was connected to pin 5.
It appears to be running to the ignition switch.

As far as the ammeter, I'm not concerned about getting it fixed because it appears most done work anyhow, I'll likely switch to a voltmeter sometime down the road.
I did check all the wiring under the hood searching for the wires with fuses that it's supposed to have and I don't see them. So it's fine. I've got some other electrical questions, but I reckon I'll start a new thread on those.

Once again, thanks for the help!