The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project~”

Grizz1963 · 04-03-2019, 12:48 PM

Bought the M10 x 75mm lightening bolts and some screw plates today.

No instructions as to drill bit size. Shaft is 10mm between threads.

Tip is 7mm but not sure thats relevant.

What is the concensus on SDS drill bit size??

8mm ?

04-03-2019, 12:48 PM	#266
Grizz1963 Registered User Join Date: Dec 2012 Location: Rochester, KENT Posts: 10,474	Re: GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project Bought the M10 x 75mm lightening bolts and some screw plates today. No instructions as to drill bit size. Shaft is 10mm between threads. Tip is 7mm but not sure thats relevant. What is the concensus on SDS drill bit size?? 8mm ? __________________ MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE.