Re: Tahoe Floor Access Plate?
Quote:
Originally Posted by Ironhorse
Sounds interesting for the way you did that. What did you use to do the cutting of the floor panel? Interested in that to get a nice straight even cut. How much room between the floor panel and the top of the tank did you have for cutting?
|
Drilled a hole in each corner, stuffed a welding blanket over top the tank, yes, total PIA. Used a saber saw after cutting off a little of the blade. If I remember correctly there was a couple inches or more between the tank and the floor. Again if I remember correctly the hole was roughly 10" square.
__________________
_____________________________
Bryan
'99 Silverado 1500, 4.3, 5-speed, reg cab, short bed
'50 Chevy 2DR Hard Top, 350/350, M2 Front End, 3:08 gear, cruiser.
'30 Model A Pickup, suicide front end, 350, 350, traditional style hot rod.
|