Quote:
Originally Posted by ls1nova71
The return side will have some pressure on it or else the fuel will just be sitting there.  The question is how much, and that's determined by how much fuel is being used at any given time, but typically it will b e a very low pressure compared to the feed line.
As for the pump sucking fuel, it can be hit or miss. There's a guy on here right now that I think is suffering from not enough fuel pressure at times, likely due to the pump trying to suck the fuel up the stock sender and then to the pump. When the pump begins to get weak, or doesn't have enough power going to it you may see a lean condition and could get a check engine light. electric fuel pumps are designed to push fuel more effectively than pulling it. I've done it both ways, used the stock sender with a pump mounted under the cab, and a gravity feed to an under cab pump. The gravity feed works much better and I have never had it starve for fuel even when the level gets low, something you will have to contend with, with a stock unbaffled tank. There are pics of both set ups in the build threads in my sig. The rusty green truck is the gravity fed one. |
okay i see you have a point lol and i see, well im going to try it out and see how it goes. i am needing help with my gauges if anyone can offer a little help on how they plumbed theirs(temp, oil press, ect..) ive got a fuel pressure gauge setup in the works but i am going to need others too. ive seen some here and there but want to see if anyone here has a good instructional thread or some direction for me, would be appreciated.