The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

VETTE10R · 10-07-2019, 10:39 PM

I've been looking for a 1st gen and finally picked one up last week! It's a 1966 step side with some work done to it. She has a 355 sbc with a little work done, 700r4 with shift kit. She has a camaro front stub and a GTO position rear end. Body is solid no rust or bondo, she does have a vibration up around 65-70 MPH. Not sure yet what that could be? Possibly bad ujoints or drive shaft out if balance? Anyways I plan on fixing that, clean up the wiring, finish the paint and add air ride. Right now she sits real low to the point the exhaust hits the ground from time to time (another thing I'll be fixing) so far I love the truck, she really turns heads and fun to drive!!

10-07-2019, 10:39 PM	#1
VETTE10R Registered User Join Date: Sep 2019 Location: Wyoming MN Posts: 47	New around here with a 66 I've been looking for a 1st gen and finally picked one up last week! It's a 1966 step side with some work done to it. She has a 355 sbc with a little work done, 700r4 with shift kit. She has a camaro front stub and a GTO position rear end. Body is solid no rust or bondo, she does have a vibration up around 65-70 MPH. Not sure yet what that could be? Possibly bad ujoints or drive shaft out if balance? Anyways I plan on fixing that, clean up the wiring, finish the paint and add air ride. Right now she sits real low to the point the exhaust hits the ground from time to time (another thing I'll be fixing) so far I love the truck, she really turns heads and fun to drive!!