running boards mounted, super easy, gets easier every time. I used some extra AD running board mounts I had laying around and trimmed them to about 11 1/2 inches in front and 13 1/2 inches in the back.
IMG_6807 by
Joe Doh, on Flickr
the front fenders had a little wiggle until we cinched the running boards down, this should be one quiet truck on the road because everything is very taut
the rear fenders were super wiggly, needed a brace I did not have. so I made one. I wanted the outside to be clean so I used some carriage bolts. I planned to bolt them to the bed too, but the drill didnt fit up where the brace went, so I just welded that side to the bed. you can still pull the fender by unbolting the carriage bolt so no foul
IMG_6806 by
Joe Doh, on Flickr
IMG_6805 by
Joe Doh, on Flickr
I even used a wing nut on the back side so it would be easy to pull off.