[bigguy]

Thanks Mud Man. Tinydb84, I can get you some pictures of the bed floor. It was pretty simple. The floor unbolts from the sides and bulkhead, then there are several spot welds at the front. I measured how high I needed to raise which was 7 1/2", and welded in a support at the front of the bed (tailgate side). I welded the floor to the sides instead of bolting it back in, but you can always just drill more holes and run bolts. As for the tubs, I cut 1/4" off the inside that mounts to the bed side. This makes it fit flush with the bed sides, then bolted it back to the bed floor. Seam sealed and raptor lined.