The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

truckzilla · 03-14-2012, 04:46 PM

On my column swap, no, I haven't seen or even heard of anyone else who has done that. I was intending on getting a tilt column from a pre '88 Chevy or GMC. The guy who I bought this one from said it would fit and after hearing his sob story about being out of work while he recovered from some injury, I went ahead and bought it from him. If it did, great, if it took some work to make it fit, OK, but my first comparison with it and the stocker was that it is probably 4 or 5 inches shorter. I'm thinking that there'll be some fab work in its future if I stick with it!
But pictures of how someone else did it would be terrific!

03-14-2012, 04:46 PM	#152
truckzilla Registered User Join Date: May 2011 Location: Fort Worth, Texas Posts: 468	Re: 1964 GMC 3/4 ton build :D On my column swap, no, I haven't seen or even heard of anyone else who has done that. I was intending on getting a tilt column from a pre '88 Chevy or GMC. The guy who I bought this one from said it would fit and after hearing his sob story about being out of work while he recovered from some injury, I went ahead and bought it from him. If it did, great, if it took some work to make it fit, OK, but my first comparison with it and the stocker was that it is probably 4 or 5 inches shorter. I'm thinking that there'll be some fab work in its future if I stick with it! But pictures of how someone else did it would be terrific!