[knomadd]

So I finally had some time to get back on the C10 wiring. I've got the instrument cluster wired and temporarily installed. I still have a long way to go. I just need the time...

Parts on order:
*CPP tilt column (to get shifter off the floor)
*Transmission linkage
*Steering wheel adapter for new Billet Specialties steering wheel
*Carpet (PO cut holes in carpet for shifter bracket, instead of just for bolts)
*Heater Controls (to fill hole in dash and keep wires from grounding out and causing problems until I get Vintage Air - PO removed the heater and all components, including controls)
*Power port and Billet plug form Watson's Street Works (cigarette lighter doesn't work and there aren't any factory knobs in the truck anymore - This allows me to use any knob with proper threads)
*CPP deluxe drop kit (1"/3" springs - already have spindles and 2" blocks - 3.5/5 total drop)
*Temp Sending Unit (for stock gauges - replaced warning light style gauges)
*Hydroboost brake booster
*Fuel line & fittings (to install new tank)
*Hidden hitch kit from ECE

Parts I have that need to be installed:
*Finish rewire
*100 amp alternator
*Fuel Tank (under bed with top filler)
*Bed floor patch (fill holes in bed floor from fuel cell/fuel lines)
*Front Bumper (stock style w/ clear lenses)
*cowl vent trash screens
*Stainless window screens (above window on doors)
*Clean/lubricate/reinstall wiper linkage
*Steering wheel
*Dash knobs (after wiring and reassembly)
*Hood bumpers (side) and adjustable bumpers (front)