Dang it, can't seem to get my uploads going for my iPad again. But I'll give an update anyway and add pics as I can.
Been super busy both at work and home.. I'm sure many can relate.. Since my last update I have worked to fabricate a pan hard bar mount, bend up brake lines, rebuild the engine and update it with full roller internals, and then today, re install the rear axle.
As soon as I rolled the axle back under the Burb, it became obvious to me that I had neglected to account for the width of the frame when I placed the tabs for the rear flex lines coming off the calipers. Bummer to say the least!
So, that meant two things, one, move the tabs, and two, bend new brake hard lines.. That should teach me to a ting or two..
Pics coming soon..
