[Duncan K]

Replaced a bit more of the back of the floor pan. Had to cut another section off the back to get access to make the repair, then weld it back in



Sliced the bottom back off the donor cab. Drivers cab corner is pretty good, but not so much for the passenger side.



My original plan was to use a whole replacement cab corner, but after comparing it with the original I could see it was going to be a lot of work to reshape the replacement. I decided to use the one from my donor. I knocked out a bunch of dents and used a small piece from the patch panel



Hung the door and fit up the rocker. Started fitting the cab corner. Have to drill some holes for the spot welds and it will be ready to weld in.



Fit up the drivers side cab corner and the rest of the back. Looks like it will work well. Have to wait until I have all the drivers side floor and braces done before I weld this stuff in