Ok so I posted this question over on the suspension forum but I thought I would give it a try here as well.......................................
I may have shot myself in the foot a little bit. Does anybody know if there is a fitting available that will screw into my wheel cylinder that will allow me to screw a 3AN fitting to it for a flex line. I put these thru frame bulkheads in the frame with the hopes of some day switching to discs. but in the meantime I was hoping to use the same set up with my drums. I have looked around but can't seem to find the right thread size for the wheel cylinder. I have seen this done on hot rods and race cars with discs. Why can't I do this with drums?? The rear doesn't know whether it has discs or drums on it. I guess I can use the conventional hard line across the rear if I have to, I was just hoping for a cleaner look on the rear.
here's a pic of what I am looking for.............
