The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**aotte1** · 10-12-2015, 10:01 PM

Randy,

But my 292 sure isn't looking outstanding like yours.

On the three nub wheels, did a rough test, and they worked, turned with out rubbing. Will do a more complete test, includes bolting them on, and report back results. Once I get the Dana 44 installed. The earlier preliminary test was holding them on the Dana 44 by hand and spinning the wheel.

Hope to start welding up the extra hole in the rear bed tomorrow.

Les

10-12-2015, 10:01 PM	#96
aotte1 Senior Member Join Date: Oct 2013 Location: lousiville Ky Posts: 2,637	Re: 64' K10 Project Long Bed Randy, But my 292 sure isn't looking outstanding like yours. On the three nub wheels, did a rough test, and they worked, turned with out rubbing. Will do a more complete test, includes bolting them on, and report back results. Once I get the Dana 44 installed. The earlier preliminary test was holding them on the Dana 44 by hand and spinning the wheel. Hope to start welding up the extra hole in the rear bed tomorrow. Les Last edited by aotte1; 10-12-2015 at 10:06 PM.