The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Fabricating my 69 C10, questions on Radiator and Disc?

jbassC10 · 06-07-2013, 01:40 PM

Okay awesome! Thanks for the tips there!! I was wondering if holes matched up or not?
Do I need to take out the cross member or can I swap the "A" arms for the new "A" arms just by unbolting and rebolting with what seems a little modifying holes?

Where do you think you'll get your master cylinder from?? As well brake lines?

~Tyler
Thanks again!

06-07-2013, 01:40 PM	#3
jbassC10 Registered User Join Date: May 2013 Location: Russellville AR Posts: 148	Re: Fabricating my 69 C10, questions on Radiator and Disc? Okay awesome! Thanks for the tips there!! I was wondering if holes matched up or not? Do I need to take out the cross member or can I swap the "A" arms for the new "A" arms just by unbolting and rebolting with what seems a little modifying holes? Where do you think you'll get your master cylinder from?? As well brake lines? ~Tyler Thanks again!