OK update time.. a small one but a good point.
Spent the last two weeks finishing the drivers side bed side replacement, setting up the 4 post lift etc.. Then it was time to get to the driver side window
- So i started with cutting the top of the bedside to make room for the window and welded on the tops of 2 doors.
- then I cut out the section where the window will go down into the boxside so it will basically rest on top of the inner bedside were it gets bolted to the fender tub.
- I purchased a set of the Electric Life Universal street rod powered window regulators to try and use them to power the rear side windows and it looks like they will fit nice. I measured and cut the one side down which you will see in the pictures of what the before and after differences in the regulators
