Re: Splined Sway Bar Sources
Quote:
Originally Posted by LS short box
In regards to the arms I mocked the mounts for the spline bar and did some basic measuring for the arms. Bought the arms and had them bent cold at a local machine shop with a press. As I recall they have various arm lengths that be shorten as needed. Again it was a bit of trial and error but its not rocket science.
Keep in mind the spline bar from Speedway Engineering is hollow so shortening and res-splining might be a bit tricky.
|
They had a narrower bar as well. I tried calling to inquire about the set-up using the shorter one but gave up after 15mins on hold.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|