![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: May 2013
Location: Catawba Island, OH
Posts: 203
|
Planetary Gear stuck - TH350
So far disassembly is going well, but now i cannot get the Planetary Gear off the shaft.
I removed the snap ring (after 30ish tries!), and it's loose of the shaft, but will not slide off. Is it that tight off a fit? Feels loose, but not over the splines? Is it a bad idea to use a gear puller? Anyone have a tip or trick to share? |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: May 2013
Location: Catawba Island, OH
Posts: 203
|
Re: Planetary Gear stuck - TH350
Ha!
Nevermind, i got it! Put my knee against the bell housing and just pulled really hard! However, any explanation as to the difficulty would make for good knowledge? |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|