Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-16-2015, 05:28 PM | #1 |
Registered User
Join Date: Dec 2012
Location: Monticello, GA
Posts: 20
|
Control arm/Suspension
Been sitting on a bunch of parts for a year now, but finally got my "New" 6.0 and 4L80. Got the itch to get it going so I can be driving it instead of dreaming.
Here's the scenario: 1968 C10 1987 crossmember JB3 LD HD CPP drop spindles 2" 87 HD 1" drop coils Polygraphite rebuild kit "performance" for 87 LD ^ New tie rod ends and steering components for 87 LD ^ New upper and lower ball joints for 87 LD Have JB5 inner/outer bearings and HD hub rotor Took the entire crossmember apart. Plan on using 87 LD arms out. After lots and lots of reading, I'm still at a loss. Pretty sure I will have to get HD ball joints, but what else? If I get a reman set of HD calipers, will there be issues mounting? Anything I'm missing? Thanks |
09-18-2015, 05:55 PM | #2 |
Registered User
Join Date: Dec 2012
Location: Monticello, GA
Posts: 20
|
Re: Control arm/Suspension
Drop spindles are CPP CP4S2
|
Bookmarks |
|
|