72 blazer door jamb measurements - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**gpat@earthlink.net** · 04-24-2013, 08:47 PM

can someone post the correct measurements between the front door jamb and the strike plate. maybe at the top middle and bottom . My floor is completely gone and i am trying to line everything back up.
Posted via Mobile Device
Posted via Mobile Device

**jaros44sr** · 04-25-2013, 07:48 AM

I think a better solution would be to hang your doors, and use them as a template. Hang all your sheetmetal to make sure it all lines up. I could give you a demension, but it might not be of any use to you, since my doors could be differant

04-24-2013, 08:47 PM	#1
gpat@earthlink.net Active Member Join Date: Jan 2011 Location: columbia, SC Posts: 156	72 blazer door jamb measurements can someone post the correct measurements between the front door jamb and the strike plate. maybe at the top middle and bottom . My floor is completely gone and i am trying to line everything back up. Posted via Mobile Device Posted via Mobile Device

04-25-2013, 07:48 AM	#2
jaros44sr Senior Member Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,704	Re: 72 blazer door jamb measurements I think a better solution would be to hang your doors, and use them as a template. Hang all your sheetmetal to make sure it all lines up. I could give you a demension, but it might not be of any use to you, since my doors could be differant __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.