Pic Needed: Roch 2bbl Carb Linkage

[bwright]

I'm trying to hookup the linkage on a rochester 2bbl carb...this carb is replacing the factory q-jet...the manifold has been swapped to the 2bbl intake. I just need a pic of the throttle bracket etc for the 2bbl. Thanks.

[bwright]

btt

[bballmac42]

i may have one ill see what i can do

[boundstaffpress]

Here is my monojet, but just like a 2GC. It is all manual from 1967. If you were to set up this carb for a cable accelerator, just attach a ball-stud in the hole that has the accel-linkage, and you will then need a bracket in the back of the intake that mounts to the intake, or the coil bracket. They are available universal from NAPA, or aftermarket.

Automatic transmission will need a kickdown. That is not shown in my picture.

[bwright]

Ah, that's my problem (thanks). I got this intake and carb from a '69 C10. It's now (temporarily, while I'm building a new engine) on my '77 C10 (cable throttle). I bought a 'universal' bracket that uses one of the carb studs, but it interferes with the linkage on the carb.

Any links to the mainfold bracket that I need?

[skokie]

Not trying to hijack the thread but what is the spring connected to near the coil?

[bwright]

My intake has a bracket on the rear that the spring attaches to (near where the coil would be...if mine wasn't HEI).

[boundstaffpress]

Here is a better picture of the spring bracket. It appears that under the grime, it attatches to the intake at the coil mounting bracket.