quest. regarding collapsing steering column - The 1947 - Present Chevrolet & GMC Truck Message Board Network

streetstar · 05-23-2008, 01:27 AM

I have read Putter's post about doing this

and have seen what one member did about re-locating the switch components (located approx 1.5- 2" back from the firewall),

but is it possible to slide that switch assembly back up and re-rivet it back in place?

PS: -- i haven't started pulling everyting apart yet because i've been using the thing as occasional transpo. --- the answer may be obvious when i drop the column, i just hadn't seen it addressed on here

Longhorn Man · 05-23-2008, 03:34 AM

it shouldn't be rivited at all. There is an adjustment in that switch... you'll see it when you drop it down.

05-23-2008, 01:27 AM	#1
streetstar Registered User Join Date: May 2007 Location: Moore, Oklahoma Posts: 2,396	quest. regarding collapsing steering column I have read Putter's post about doing this and have seen what one member did about re-locating the switch components (located approx 1.5- 2" back from the firewall), but is it possible to slide that switch assembly back up and re-rivet it back in place? PS: -- i haven't started pulling everyting apart yet because i've been using the thing as occasional transpo. --- the answer may be obvious when i drop the column, i just hadn't seen it addressed on here __________________ Are you retired too? Nonsense! I'm in my prime Last edited by streetstar; 05-23-2008 at 01:27 AM.

05-23-2008, 03:34 AM	#2
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,693	Re: quest. regarding collapsing steering column it shouldn't be rivited at all. There is an adjustment in that switch... you'll see it when you drop it down.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.