|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-15-2023, 12:14 PM
|
#1 |
|
Registered User
Join Date: Feb 2016
Location: Texas
Posts: 52
|
Upper ball joint question
On a 72 C10 1/2 ton, I know the lower ball joints are pressed in, but are the upper ball joints pressed in or just held in by the 4 screws on the top? Thanks.
|
|
|
|
07-15-2023, 12:27 PM
|
#2 |
|
Senior Member
 Join Date: Mar 2003
Location: Colfax-California
Posts: 8,407
|
Re: Upper ball joint question
Unless they've been changed before (which is very likely) it is riveted in. So all you have to do is support the lower A arm on a floor jack or jack stand and unbolt the ball joint from the spindle and remove the 4 bolts or rivets
|
|
|
|
|
07-18-2023, 10:59 AM
|
#3 |
|
Registered User
Join Date: Jan 2007
Location: Puyallup, WA
Posts: 1,661
|
Re: Upper ball joint question
Correct, rivets from factory and bolts for replacements
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
