|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-14-2016, 07:25 PM
|
#1 |
|
Registered User
 
Join Date: Sep 2001
Location: Fort Wayne, Indiana, USA
Posts: 1,880
|
Temp gauge wire routing
What is the correct/best routing of the green/insulated temp sensor wire from the firewall to the terminal? Photos may help! Thx
|
|
|
|
05-14-2016, 08:51 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Wisconsin & Arizona
Posts: 4,841
|
Re: Temp gauge wire routing
The original routing was in a fabric loom along the valley formed by the left valve cover and intake manifold. My original 350 left valve cover had a couple retainer clips for attachment. At the front, it dropped down to a clip retained by the bottom water pump bolt/stud then back and up to the temperature sensor.The pictures below show the routing. In the second picture the bolt/stud is in the wrong (top) hole.
EDIT: Added 3rd pic. Last edited by FirstOwner69; 05-14-2016 at 09:03 PM. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
