|
12-24-2019, 06:08 PM
|
#1 |
|
Senior Member
 
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
rear brake line pic
can some one send me a pic of the rubber hose connection fitting from the two hard lines on the read axle tubes that connects to the frame rail long line that runs to the front of the truck, I think i am missing a fitting
or what connects to this end of the rubber hose, see pic
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|
|
|
|
12-24-2019, 07:06 PM
|
#2 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,413
|
Re: rear brake line pic
That end would go the steel line on the frame. The other end of the hose should be a built in female T where the lines come from each wheel cylinder
|
|
|
|
|
12-24-2019, 09:57 PM
|
#3 |
|
Post Whore
Join Date: Feb 2016
Location: Portland Oregon
Posts: 10,906
|
Re: rear brake line pic
What year and model of truck? There are differences over the years and between K and C models and between coil and leaf springs on the axle end.
The first photo shows a 67 C10 axle set up. Which I believe is the same through 70. In the second photo the larger hose is the brake hose. It goes through the frame above the spring to the fitting on the hard line. The correct hole in the frame should be D shaped. A clip like the front hoses (3rd photo red arrow) use will secure the hose to the frame. Red arrow in 2nd photo points to the location of the clip behind the frame stiffener for the spring base. Good luck. I hope this helps.
__________________
Thanks to Bob and Jeanie and everyone else at Superior Performance for all their great help.  RIP Bob Parks. 1967 Burban (the WMB),1988 S10 Blazer (the Stink10 II),1969 GTO (the Goat), 1970 Javelin, 1952 F2 Ford OHC six 4X4, 29 Model A, 72 Firebird (the DBP Bird). 85 Alfa Romeo If it breaks I didn't want it in the first place The WMB repair thread http://67-72chevytrucks.com/vboard/s...d.php?t=698377 Last edited by HO455; 12-24-2019 at 10:34 PM. |
|
|
|
|
12-25-2019, 03:55 PM
|
#4 |
|
Senior Member
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: rear brake line pic
All thanks for the replies. I actually poured me a big Dickel and coke last nite and went out and just drank my drink and looked at the frame, and it hit me after a few sips. On how i took it apart a year ago. On my 72 there is a steel tab sticking out of the cross brace behind the differential like the last picture from HO455. and it all came together
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks
|
|
|
|
|
12-25-2019, 06:19 PM
|
#5 |
|
Registered User
Join Date: Nov 2012
Location: 9
Posts: 862
|
Re: rear brake line pic
Here are some stock photos I took before tear down. 72 C10
|
|
|
|
|
12-25-2019, 08:47 PM
|
#6 | |
|
Registered User
Join Date: Nov 2011
Location: Omaha, Nebraska
Posts: 432
|
Re: rear brake line pic
Quote:
__________________
Travis' Tribute Truck - 65 C10 Frame Up Restoration http://67-72chevytrucks.com/vboard/s...d.php?t=495073 |
|
|
|
|
|
12-29-2019, 02:22 PM
|
#7 | |
|
Senior Member
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: rear brake line pic
Quote:
sprint 9 thanks for the pics , I am running new brake lines currently
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks
|
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
