Vortec heads,headers,spark plugs

[SoCal71K20]

What's a good plug to run with headers and
vortec heads?I'm looking for a little more
clearance with my Hedman's. Delco R44LTS
plugs seem the same length as the old R44's
I ran with the old heads.Anyone know if Delco
MR43LTS plugs are a little shorter?Any other
US made Brands? Thanks.

[Longhorn Man]

While i can not speak for your part # plug, i know the ones I use (Bosh) are shorter than any of the other 'run of the mill' plug. This is not including all th special header plugs.
THe ones I get are the .99 cent ones at Auto Zone.

------------------
'69 G.M.C. 350/350. Trying to clean up the left over damage from the Dope-Smokin-Old-Man
I've been dubbed the Longhorn Freak/Fanatic/Expert, I just hope I can live up to it.
FINALLY got the HORNIAC...a '70 one ton Longhorn with a Pontiac 350/350 and lots of 'personality'. Check out The Longhorn Webite.
E-mail longhornmail@yahoo.com
My name is Andy...not Randy...I'm in Ohio...Not Illinois...close enough?
Columbus Ohio

[70shortnphat]

I have the 2001 Edlebroc catalog and they have a tech. tip on page 104 that states "To gain more spark plug clearance ........, we advise using a Champion RC series plug, such as an RC12yC. These spark plugs a 0.230 shorter than a conventional plug and have a 5/8" hex for easier access in tight locations."
Sounds like they might be worth a try.

------------------
1970 short bed fleetside
Richmond , Texas(just S.W.of Houston)