|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-29-2005, 04:10 AM
|
#1 |
|
Registered User
Join Date: Mar 2005
Location: Chico, CA
Posts: 42
|
rivets in upper ball joints, cut them???
I am about to lower my 72 chevy c/10, I am going to put all new ball joints in it, I noticed the uppers were riveted together, do I just cut them apart, or am I missing something here?
__________________
1972 chevy C/10, with factory air, SWB, 350,700r4, lowered 3 and 5. |
|
|
|
03-29-2005, 04:11 AM
|
#2 |
|
Senior Member
Join Date: Apr 2000
Location: Delta,Pa
Posts: 14,950
|
grind the rivet heads off and knock them through then use bolts to put the new ball joints in
__________________
Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member. |
|
|
|
|
03-29-2005, 08:44 AM
|
#3 |
|
Watch out for your cornhole !
 
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Your new ball joints will come with the bolts and nuts.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
|
03-29-2005, 10:37 AM
|
#4 |
|
68cst_ss490
Join Date: May 2001
Location: edmonton,canada
Posts: 1,363
|
Use an air hammer with a chisel tip and cut them. it makes it easier if you heat the heads of the rivets with a torch, then they cut like butter.
__________________
Dean edmonton,canada a winter wonderland 2005 Chevrolet Avalanche LT cold air intake, performance exhaust, Comp cams cam, jba shorty ceramic headers. http://www.cardomain.com/ride/3090973 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
