Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
03-29-2014, 11:33 PM | #1 |
Registered User
Join Date: Sep 2013
Location: Dallas, Texas
Posts: 4
|
remote solenoid install, key in run position starter runs
Trying to install a painless remote solenoid.
Engine turns over and starter runs continuously as soon as key hits run position. A po owner had a reman installed about 7 years ago. A black wire and a red wire come up from the starter to the firewall. I believe the black wire originally went down to the S terminal on the starter solenoid and so I rerouted it to the middle terminal on the remote solenoid. I'll try to post a picture of what I've done so far |
03-30-2014, 04:43 AM | #2 |
Registered User
Join Date: Sep 2013
Location: Dallas, Texas
Posts: 4
|
Re: remote solenoid install, key in run position starter runs
I figured it out and got it done. I had confused the wires connected to the starter "s" and "r" terminals.
|
03-30-2014, 01:14 PM | #3 |
Registered User
Join Date: Sep 2013
Location: Dallas, Texas
Posts: 4
|
Re: remote solenoid install, key in run position starter runs
I'm glad I installed the remote solenoid.
I think the wires to the s terminal and the r terminal were both damaged by heat. The r terminal on the start er is really close to the headers. The truck runs better now. BTW I left the original battery cable in and just moved the connection from the battery + to the right side of the remote solenoid. |
Bookmarks |
|
|