|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-02-2016, 01:56 AM
|
#1 |
|
Registered User
Join Date: Jan 2015
Location: Los Angeles California
Posts: 927
|
Factory floor insulation
Are there any suppliers for the factory original foam/tar board insulation? My burb has the original thick factory undercoating that keeps it pretty quiet and the stock stuff worked well to keep the heat out. I just took out the old stuff and it was pretty brittle and smashed after 44 years. If no kits anyone have a source for the tar mat?
Thanks |
|
|
|
05-02-2016, 05:25 AM
|
#2 |
|
Senior Member
 
Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: Factory floor insulation
I think I saw them at manestruckparts.com
__________________
 1967 Factory short bed - Old school '71 - 350 / 4bolt / 487 heads / Edelbrock C3BX Muncie M-22 4 speed / Hurst Comp plus Factory 12 bolt posi 3.73 / 255-70-15 Smoothed firewall / Factory cowl induction Power disc brakes / power steering / 3.5-5" drop |
|
|
|
|
05-02-2016, 05:46 AM
|
#3 |
|
20' Daredevil (Ret)
Join Date: May 2003
Location: Jefferson State
Posts: 13,533
|
Re: Factory floor insulation
Check with any board vendor. Brothers has this small hump (large hump also available). http://www.brotherstrucks.com/67-72-...tinfo/UCSP002/
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
