Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
06-11-2019, 01:15 PM | #1 |
Active Member
Join Date: Jun 2016
Location: Salida, CA
Posts: 177
|
How to keep a panel popped out
I’m doing body work on my 70 C10 longbed fleetside, working on the bedsides. At the rear of one, the outer panel is dented and popped in. I can pop it out by pushing from the other side but it wants to pop back in. I’ve been doing studs and a slide hammer around the outside but it’s only helping minimally. Do I need to cut the whole area off and work at it that way? I’m new to bodywork if it isn’t obvious.
__________________
David Larsen 1970 Chevrolet C-10 Last edited by dflarsen77; 06-11-2019 at 01:21 PM. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|