Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
02-10-2006, 08:51 PM | #4 | |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,924
|
Re: kp components weld in step notch
Quote:
I've tried calling them (3x during business hrs) & have sent e-mail (1x so far w/no response). I then tried to contact a distributor for them & haven't heard back from him either! At this rate, I'm afraid of what would happen if something didn't go right..... How hard would they be to contact then? I'm going to try the distributoor again tomorrow since he's supposed to be open from 10 ~ 5 on Sat's.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
Bookmarks |
|
|