Quote:
Originally Posted by 68 short step
ill add insult to injury too, i broke my feed fitting (like you) and replaced it with a fitting i found at ACE hardware...... this fitting was on the fitting shelf (you know the ones that people get the fittings, and instead of putting it where it belongs they put it on the shelf below) it was only 1.25$, but didnt see another like it..altho i quit looking when i saw it... so shift hurry up and git it going......
|
Pump is reassembled with all new fittings (only cost a couple of bucks
). I started the lines already also, and moutned my fuel pressure regulator. First two lines from pump to regulator are done, just need to complete the single main line to the front, which I want to take some time with to do it clean. I'm that much closer, but working on a computer for a board member today. Hope to finish the fuel lines by end of day, then need to get the tank primed, install the radiator hoses and fill it with coolant, then run a few wires. Won't get it finished today, but at least I'm close to cranking ....
__________________
If I've got anything up for grabs, it'll be here: 7-hole gauge cluster for a 67-72 p/u FREE (
link)
I can't check the forum daily. If I don't reply to you within 24 hours,
drop me a PM! I'm (hopefully) still alive and will reply faster to a PM.
03-25-2007, 03:02 PM
Threaded Mode