Those with ECE 2" drop in front

[OhOneWS6]

How much did you cut off the bump stops?

I finally let mine down off the jack stands after rebuilding the front end. I noticed tonight it is sitting on the bump stops. I put a tape measure to it and it is sitting 2.25" lower than when I started but I think it would go lower if it wasn't for the bump stops. It is bottomed out on both sides.

It was rebuilt with all Moog parts and 2" drop springs. I also installed new upper and lower rubber bump stops and KYB shocks. All parts are from ECE.

How I measured it.


Close up of before measurement.


After measurement.


Bump stop bottomed out. (Before anyone says it, I know I need to seat the lower ball joint seal. LOL.)