NP 205 Rebuild and Info - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jbclassix · 08-14-2014, 09:48 PM

Do you have the linkage between the two rods? There are interlock pins between the rods, they prevent the rods from moving out of sync from each other. If you are in 4-Low, then both rods should move out at the same time to NEUTRAL. then the top rod should move out one more time to 2-HI, then the bottom rod should move out one more time to 4-HI.

If you are trying to get the top rod into 2-HI with the bottom rod in 4-LOW then it will not go because of the interlock pins.

08-14-2014, 09:48 PM	#14
jbclassix Junk Yartist Join Date: Jul 2009 Location: Greeley, CO Posts: 2,203	Re: NP 205 Rebuild and Info Do you have the linkage between the two rods? There are interlock pins between the rods, they prevent the rods from moving out of sync from each other. If you are in 4-Low, then both rods should move out at the same time to NEUTRAL. then the top rod should move out one more time to 2-HI, then the bottom rod should move out one more time to 4-HI. If you are trying to get the top rod into 2-HI with the bottom rod in 4-LOW then it will not go because of the interlock pins. __________________ -Jeremy YOU ONLY FAIL IF YOU STOP TRYING 70 Crew Cab Build Link 70 GMC Suburban 4X4 build thread 95 Yukon Daily Driver Rebuilding an NP205



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.