Did i screw up my cam break in?

[68basket]

SO i refreshed my 283 with all new gaskets, valve springs, timing set, cam and lifters. I used valvoline 20-50 oil that says it has enough zinc for flat lifter engines., I ran in for 20 min at 2000 rpm then drained oil. Engine sounds perfect. added new oil and filter, then noticed i left the small bottle of cam break in lube on the shelf! Do i need to add the bottle and re do my 20 min break in? or should i be ok to just run it as it is? Note this is not an engine rebuild. Just all new seals, head gaskets, valve seals and springs, timing set and cam and lifters.