ID '63-'66 Power Brake Booster Bracket With Hydraulic Clutch Conversion

[J1MMY]

http://67-72chevytrucks.com/vboard/a...1&d=1310359367

I thought I'd feed this back publicly, not to find fault with the product but in case anyone else has found a similar issue.

On the kit you sent out to me the block that is fixed through the lower clutch cylinder bolt is different - see pic below. I'm guessing that this is simply product refinement



The issue that I have is that using the format as set out in your guidance pics the plunger rod for the clutch is pulled downwards instead of straight outwards.

If I alter the format as shown in the pic below then the plunger rod sits straight and the rod from the clutch pedal pivots on the middle hole of the plate that unifies all three rods. To make that work, the plate has to be filed.

Also, the extra cut plate that sandwiches between the clutch cylinder and the firewall renders the bolts too short. Is this plate simply for reinforcement or to help with pedal travel? See pic below: