Has anyone ever "opened up" their center crossmember to fit a one piece drive shaft? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network

Click Here



Register or Log In To remove these advertisements.

		The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board
Has anyone ever "opened up" their center crossmember to fit a one piece drive shaft?

Site Merchandise

Prev

Previous Post

Next Post

Next

01-08-2018, 03:20 PM	#1
superhondaz50 Registered User Join Date: Mar 2007 Location: Behind the Taco Bell dumpster Posts: 296	Has anyone ever "opened up" their center crossmember to fit a one piece drive shaft? I've been toying with the idea of a one piece driveshaft, aluminum 5" round for my lifted lwb truck. (A ram driveshaft might fit the bill, I need to measure). To do it I'd need to weld new bottom bracing onto the crossmember them cut out the old portion. Has anyone done this, or see any crazy issues doing this? Thanks Last edited by superhondaz50; 01-08-2018 at 03:21 PM. Reason: Spelling correction.

Bookmarks

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 04:04 AM.