GA 64 passenger fender - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**cwcarpenter98** · 05-02-2020, 10:42 PM

My 63 fender has some rust in it, but it is still repairable. If I put this one on my truck, I'll have to drill new holes for the 63 badge and fill the holes for the 64 badge. Frankly, I don't really want to do that, so this fender is available until I change my mind and decide that drilling two holes and filling two others is easier than replacing a whole section.

It has been repainted, but I have not found any visible rust through. Unfortunately, the lower rear looks to have been dented and filled with bondo. From the glimpse through the drain hole, I could see a couple bondo boogers, but I don't see any concerning rust around said boogers. One dent towards the top of the fender around where the seam on the hood is.

I am keeping the fender badge.

$120 I would prefer local pickup, but if needed, I could get UPS to box it up and ship it.

SOLD

05-02-2020, 10:42 PM	#1
cwcarpenter98 Senior Member Join Date: Jan 2018 Location: Hickory Flat, GA Posts: 4,439	64 passenger fender My 63 fender has some rust in it, but it is still repairable. If I put this one on my truck, I'll have to drill new holes for the 63 badge and fill the holes for the 64 badge. Frankly, I don't really want to do that, so this fender is available until I change my mind and decide that drilling two holes and filling two others is easier than replacing a whole section. It has been repainted, but I have not found any visible rust through. Unfortunately, the lower rear looks to have been dented and filled with bondo. From the glimpse through the drain hole, I could see a couple bondo boogers, but I don't see any concerning rust around said boogers. One dent towards the top of the fender around where the seam on the hood is. I am keeping the fender badge. $120 I would prefer local pickup, but if needed, I could get UPS to box it up and ship it. SOLD Attached Images __________________ Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson Last edited by cwcarpenter98; 05-11-2020 at 12:39 PM. Reason: Mike picked it up today.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.