Frankentruck - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**cwcarpenter98** · 05-26-2021, 11:54 AM

Had to do some school work yesterday for my 2 summer classes, so didn't work on the new bed at all.

This morning I drilled the holes in the new flange. After that was done, it was time to paint the bare metal and where the wheel tub mounts. I also cleaned and painted the flanges on the wheel tubs to slow down the rust in those spots.

Probably should have gone to get some paint that matches a little better, but I'm hoping that the gloss will fade out some in the sun and be close enough for now. I used the same can on the driver's door last summer, and it matches up fairly well now. You have to look really close to see it.

Time for lunch!

05-26-2021, 11:54 AM	#11
cwcarpenter98 Senior Member Join Date: Jan 2018 Location: Hickory Flat, GA Posts: 4,432	Re: Frankentruck Had to do some school work yesterday for my 2 summer classes, so didn't work on the new bed at all. This morning I drilled the holes in the new flange. After that was done, it was time to paint the bare metal and where the wheel tub mounts. I also cleaned and painted the flanges on the wheel tubs to slow down the rust in those spots. Probably should have gone to get some paint that matches a little better, but I'm hoping that the gloss will fade out some in the sun and be close enough for now. I used the same can on the driver's door last summer, and it matches up fairly well now. You have to look really close to see it. Time for lunch! Attached Images __________________ Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.