Boyd Welding-67-72 Rear Mount Aluminum Tank

[Daveboyd]

Originally Posted by btullis99

dave, what kind of vent is recommended to run in the top 3/8npt hole? i've been looking around some on the net and can't seem to locate one anywhere. any recommendations?

alot of people just put a 90 degree hose barb and a length of hose on it.

I prefer to use this combination of parts when i can. You can find these at jegs.com

roll over vent part #RCI #821-7021A



and fitting adapter part#JEGS #555-100147

[btullis99]

Originally Posted by Daveboyd

alot of people just put a 90 degree hose barb and a length of hose on it.

I prefer to use this combination of parts when i can. You can find these at jegs.com

roll over vent part #RCI #821-7021A

and fitting adapter part#JEGS #555-100147

perfect, sounds great. i'll get those ordered.

[silver7]

Originally Posted by Daveboyd

alot of people just put a 90 degree hose barb and a length of hose on it.

I prefer to use this combination of parts when i can. You can find these at jegs.com

roll over vent part #RCI #821-7021A



and fitting adapter part#JEGS #555-100147

Dave,

I bought this set-up shortly after I received my tank over 12 months ago only to later realize this must have been posted before you supplied a vent since the thread size on this is different than the vent thread size you supplied with the tank I received. I plan to plug my return opening since I don't need it, so my question is which vent is better - this vent from JEGS or the vent I received with the tank?

Thanks,
Shawn