Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
10-29-2018, 03:37 PM | #11 |
Registered User
Join Date: May 2012
Location: horseheads,ny rust belt
Posts: 2,794
|
Re: budget beater c10 to k30 swap over build.
fuel system passed the pressure test today . dumped 7gal of gas in the both tanks and the new autometer gauge read just about 1/4 tank ( 20 gal tanks ) knowing oem always kind of sucked i call that good .
so i then powered up the main tank with the autometer pressure gauge in and powered up . she come up to 60 psi kind of slow but i figure that was from 100% empty/new system . then i let her sit there and run for a min or so and she held 58-59 psi the whole time just a hair under the 60 psi mark . then power off to pump and wait 5 sec and repower and she come right back up . i then sent power to the transfer tank / pass side and she feed fuel over to the main tank nice and easy . i also got 6 qrt of brad penn 30 weight breakin oil / high level zink & phos . put 5 in the engine after i pre filled the filter 98% of the way up before install on engine . other than finding TDC #1 to set the dist in the hole for good i think we are ready for body set down and start hooking up a few wires and coolant hoses for a fire off and see what we get . budget beater plow machine
__________________
77-k30lb BIG truck build . 87-k30lb budget beater build . 85-k30lb the plow machine build . 85-c10sb summer fun toy . ----------------------------- HOLLEY SNIPER efi = worst case of p.i.t.a i ever had . EDELBROCK pro flo 4 = best deal going so far . love my setup works great. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|