What did you do to your truck today.The 3rd chapter - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Davidf · 08-31-2020, 10:44 AM

Removed about 3/8" of body filler on the corner of my hood only to find poorly repaired previous damage. The bondo sculptor was not very good as the corner was way different than the other side. So, I opened her up to get some of the metal back to normal. Notice the single vertical cut and how far it opened up to get the metal close to where it belongs. Any suggestions on making a (compound curve) patch panel? A patch panel would sure come in handy if any has one available.

08-31-2020, 10:44 AM	#11
Davidf Registered User Join Date: Nov 2014 Location: Austin Posts: 749	Re: What did you do to your truck today.The 3rd chapter Removed about 3/8" of body filler on the corner of my hood only to find poorly repaired previous damage. The bondo sculptor was not very good as the corner was way different than the other side. So, I opened her up to get some of the metal back to normal. Notice the single vertical cut and how far it opened up to get the metal close to where it belongs. Any suggestions on making a (compound curve) patch panel? A patch panel would sure come in handy if any has one available. Last edited by Davidf; 08-31-2020 at 05:38 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.