![]() |
![]() |
#1 |
Senior Member
Join Date: May 2005
Location: Portales, NM
Posts: 359
|
Does anybody know?
does anyone know the spacing/location of the mounting holes on a 60-62 Rear Fleet bumper.
And the mounting hole spacing/location on a 63-66 rear fleet bumper since the 63-66 rear frames are 33 3/4 inches wide and the 60-62 are 41 3/4 inches wide. one like this:
__________________
________________________ 62' ![]() 08' Chevrolet Silverado CrewCab 05'Toyota Tacoma Prerunner SR5 Last edited by 62ChevyStep; 02-20-2007 at 05:39 PM. |
![]() |
![]() |
![]() |
#2 |
Registered User
![]() Join Date: Oct 2006
Location: San Jose NOR*CAL
Posts: 3,080
|
Re: Does anybody know?
I will mesure my 60's when I get home
Last edited by slepysal; 02-20-2007 at 06:28 PM. |
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: May 2005
Location: Portales, NM
Posts: 359
|
Re: Does anybody know?
thanks Slepysal......62Chevystep
__________________
________________________ 62' ![]() 08' Chevrolet Silverado CrewCab 05'Toyota Tacoma Prerunner SR5 |
![]() |
![]() |
![]() |
#4 |
Registered User
![]() Join Date: Oct 2006
Location: San Jose NOR*CAL
Posts: 3,080
|
Re: Does anybody know?
ok it mesured 13.75 inches from center to center. The blue lines
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2005
Location: Portales, NM
Posts: 359
|
Re: Does anybody know?
Thanks, I have been unable to find an OEM 60-62 fleet bumper like the one in the picture (it is off a 63-66). I know I can purchase an aftermarket one, but they often are not the same structural quality as the OEM ones, so if I cannot find a OEM 60-62 fleet bumper like the one shown, I will take this one weld the holes and redrill for the 60-62 brackets.
I have a perfect OEM front bumper, so will take both and have them show chrome plated when the time comes.
__________________
________________________ 62' ![]() 08' Chevrolet Silverado CrewCab 05'Toyota Tacoma Prerunner SR5 |
![]() |
![]() |
![]() |
#6 |
Registered User
![]() Join Date: Oct 2006
Location: San Jose NOR*CAL
Posts: 3,080
|
Re: Does anybody know?
you know you can allways "shave '" it , weld the original holes, and weld in the new bolts in the rigght location ,leaving a clean shaved bumper. We used to call them CAL Bumpers.
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: May 2005
Location: Portales, NM
Posts: 359
|
Re: Does anybody know?
yeah I didn't think of that, we use to do that on volkswagons in Cali back in the day (70's and 80's) Uh oh starting to age myself.
__________________
________________________ 62' ![]() 08' Chevrolet Silverado CrewCab 05'Toyota Tacoma Prerunner SR5 |
![]() |
![]() |
![]() |
Bookmarks |
|
|