Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
06-17-2007, 02:16 AM | #1 |
Tripple Five Fanatic
Join Date: Sep 2006
Location: USA
Posts: 658
|
Re: Project "Tracy Lee" 59 Apache
Wow, they are visable! If you chop some out wouldn't that affect the seatbelt? Did you also made brackets for them?
Tri5 |
06-17-2007, 12:04 PM | #2 | |
Registered User
Join Date: Dec 2004
Location: Southeast Tx
Posts: 1,302
|
Re: Project "Tracy Lee" 59 Apache
Quote:
There are a couple of what I think are "extra" holes in the floorboard. I just measured width-wise from the top lip of the interior step to the other and calculated where they should sit. The inside front corners of the seats matched up with an exsisting hole so I drilled it out a little wider to accomidate my new grade 8 bolts. I used 3/8 x 2in there. On the outside fronts I used 3/8 x 3in. I had to drill new holes for that. The rear of the seats is another story. I drilled all new holes for them. I do need to go back and fab up some kinda short spacer between the seat and floor so the seats will slide smoother back and forth. I'll be doing that today.
__________________
"The rays of light thru the Shiner Bock bottle make me wanna turn the key and put down the throttle...and get lost down 35" - Jason Boland www.YouTube.com/user/593Films - Watch My Videos! 1977 Silverado K10 2014 Dodge Durango (Wife-mobile) 2008 Dodge Ram Lone Star Edition (Daily driver) |
|
Bookmarks |
|
|