|
03-05-2002, 10:15 PM
|
#1 |
|
king $h!t
Join Date: Jan 2002
Location: spring valley/ohio/usa
Posts: 416
|
help cross member
ok i hope some one can tell me how many crossmembers there are i have two one under the transfer case and one under the trans on my blazer and what is funny bout this is ive seen alot of the blazers that were all lifted the only have one and its on the trasfer case
__________________
j dawg the 86 allmost done 357/700r4/lifted 9/dana44 front ten bolt rear/3.73 gears/35s |
|
|
|
03-05-2002, 10:29 PM
|
#2 |
|
Registered User
Join Date: Feb 2002
Location: Kansas
Posts: 10
|
You should have only 1 crossmember (at least that's how my 79 blazer is) it's what the transfer case adaptor (between trans and t-case) bolts to. Owner before you might have put one in to act as a skid plate.
[This message has been edited by dr_mi (edited March 05, 2002).] |
|
|
|
|
03-06-2002, 07:40 PM
|
#3 |
|
Registered User
Join Date: Jan 2002
Location: Peoria, AZ
Posts: 115
|
you will have two if your blazer is like mine. I think it was for a skid plate or something because it doesn't have anything else hooked to it.
------------------
__________________
1973/1997 Blazer/Tahoe (it just doesn't know that it is a '73) 
|
|
|
|
|
03-06-2002, 08:01 PM
|
#4 |
|
king $h!t
Join Date: Jan 2002
Location: spring valley/ohio/usa
Posts: 416
|
well im pulling the one off cause i dont need it and it messing with the lift
__________________
j dawg the 86 allmost done 357/700r4/lifted 9/dana44 front ten bolt rear/3.73 gears/35s |
|
|
|
|
03-06-2002, 09:41 PM
|
#5 |
|
Account Suspended
Join Date: May 2000
Location: IL
Posts: 0
|
pull the one under the transmission, not the one under the transfer case, or.,,,,,
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
