Make it handle - The 1947 - Present Chevrolet & GMC Truck Message Board Network

69gmcc10 · 08-31-2012, 03:42 PM

How about polly bushings for shocks? are they a worthwhile upgrade or an upgrade at all?

Rstone1 · 08-31-2012, 05:36 PM

I asked this question earlier and got no responce so I will ask again.

Inclination between the lower and the upper ball joint in the spindle. Is this needed, what is it used for and where is a good range to be in if it is needed?

**robnolimit** · 09-04-2012, 04:04 PM

Quote:

Originally Posted by 69gmcc10

How about polly bushings for shocks? are they a worthwhile upgrade or an upgrade at all?

Shocks only work when the shaft moves. So, anything that soaks up the transfer of suspension movement from the shock shaft is bad. shocks are one of the components that when it comes to performance, I'd go straight to bearing mount. But, urathane bushings are a big + from stock rubber.

08-31-2012, 03:42 PM	#1
69gmcc10 Registered User Join Date: May 2011 Location: Missoula, MT Posts: 934	Re: Make it handle How about polly bushings for shocks? are they a worthwhile upgrade or an upgrade at all? __________________ 69 GMC C10 build thread- http://67-72chevytrucks.com/vboard/s...d.php?t=501676 03 Silverado build thread-http://67-72chevytrucks.com/vboard/s...d.php?t=591582

08-31-2012, 05:36 PM	#2
Rstone1 Registered User Join Date: Apr 2011 Location: Turlock, Ca Posts: 29	Re: Make it handle I asked this question earlier and got no responce so I will ask again. Inclination between the lower and the upper ball joint in the spindle. Is this needed, what is it used for and where is a good range to be in if it is needed?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.