The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1969 - 1972 Blazers and Jimmys Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 01-15-2016, 09:33 PM   #1
Sandtrap9072
Senior Member
 
Sandtrap9072's Avatar
 
Join Date: Apr 2012
Location: Michigan
Posts: 389
1972 Gmc Jimmy Wire Identification

So, I am cleaning up some wiring in the engine compartment and came to a purple wire that was spliced into a red wire that runs to the starter. Can anyone tell me what their purple wire runs to, this doesn't seem right? Please see attached pictures. Also, where the red and purple wires are spliced, there is a green wire and a black wire that are cut, does anyone know where these are supposed to run to? Any help would be greatly appreciated.
Attached Images
  

Last edited by Sandtrap9072; 01-15-2016 at 10:10 PM.
Sandtrap9072 is offline   Reply With Quote
Old 01-15-2016, 10:55 PM   #2
jaros44sr
Registered User
 
jaros44sr's Avatar
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,432
Re: 1972 Gmc Jimmy Wire Identification

sandtrap, not to put you off, but I don't know the answer to your question. But, I do know that if you drop down into the electrical section there is a colored wiring diagram of the entire wiring harness. I will follow along to make sure you get it sharpened out. Please post a follow up, so I can see where you ended up

To many whiskies to type
__________________
Semper Fi...Uncle Sam, you da man

All parts offered to help are free, unless otherwise noted

Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST

AS usual, off topic

They say your mind goes second, can't remember the first


Jim
jaros44sr is offline   Reply With Quote
Old 01-16-2016, 10:24 AM   #3
hemi43
Registered User
 
hemi43's Avatar
 
Join Date: Mar 2015
Location: Ontario Canada
Posts: 1,501
Re: 1972 Gmc Jimmy Wire Identification

Purple wire comes from the starter switch (hot on start) then goes to the neutral safety switch at the bottom of column,and then goes to the solenoid on the starter. My guess is that the original wire got damaged because it's near the exhaust, so the previous owner spliced in the new red wire.
hemi43 is offline   Reply With Quote
Old 01-16-2016, 10:26 AM   #4
Sandtrap9072
Senior Member
 
Sandtrap9072's Avatar
 
Join Date: Apr 2012
Location: Michigan
Posts: 389
Re: 1972 Gmc Jimmy Wire Identification

Sweet, thanks guys. What about the green and black wire shown in the second picture?
Sandtrap9072 is offline   Reply With Quote
Old 01-16-2016, 12:33 PM   #5
hemi43
Registered User
 
hemi43's Avatar
 
Join Date: Mar 2015
Location: Ontario Canada
Posts: 1,501
Re: 1972 Gmc Jimmy Wire Identification

Quote:
Originally Posted by Sandtrap9072 View Post
Sweet, thanks guys. What about the green and black wire shown in the second picture?
I tried to find out, but since my truck is a 70 it's a bit different. I have a feeling it may be for emission controls but I'm not sure, sorry.
hemi43 is offline   Reply With Quote
Old 01-16-2016, 01:11 PM   #6
ls1nova71
Registered User
 
ls1nova71's Avatar
 
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,118
Re: 1972 Gmc Jimmy Wire Identification

Green wire looks like the temp sender wire. As for the black one, you'll have to trace it back and see where it goes. If it goes into the bulkhead connector, post a pic of where and we can figure it out from there. I would also trace the green one to make sure it goes to the bulkhead too, it's just with that aftermarket wire loom you never know what a previous owner could have put in there.
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html

5.3 swap into my RUSTY '71 C10
http://ls1tech.com/forums/conversion...71-c-10-a.html
ls1nova71 is offline   Reply With Quote
Old 01-16-2016, 07:28 PM   #7
87Skier
Registered User
 
87Skier's Avatar
 
Join Date: Mar 2014
Location: Corvallis, OR
Posts: 711
Re: 1972 Gmc Jimmy Wire Identification

Mine had a TCS (transmission controlled spark) module but most of the components were missing. It came out about where you were talking about. I redid my wiring and eliminated this stuff.

Look at this link:
http://67-72chevytrucks.com/vboard/s...d.php?t=196397
__________________
1972 GMC Jimmy Custom 4.8L (L20)/6L90E/NP205
1989 Chevy Suburban V2500 350/Turbo 400/4.11 gears
1996 Chevy Suburban K1500 350/4L60E
87Skier is offline   Reply With Quote
Old 01-18-2016, 01:05 PM   #8
Sandtrap9072
Senior Member
 
Sandtrap9072's Avatar
 
Join Date: Apr 2012
Location: Michigan
Posts: 389
Re: 1972 Gmc Jimmy Wire Identification

Thanks for all of your helps fellas, i haven't been able to make it back out into the garage lately. But when i do ill look into the black wire.
Sandtrap9072 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:53 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com